Most Useful Tips on How to Replace a Windshield

If you have a chip or crack on the windshield, there is a high likelihood that it will keep growing which will make it an attractive and also dangerous. As you probably know, when you take your car to a repair shop for new windshield, it can be expensive and sometimes unnecessary, and this is why you should learn how to replace the windshield by yourself. This article is going to provide you with more information about the best tips on how you can replace the windshield.

The first step to take is to remove the old damaged windshield from your vehicle. To remove the old damaged windshield, remove the rubber trim, then peel the gasket from the groove around the glass and finally remove the clips that keep the molding place. Using a razor, cut the urethane seal so that to separate the windshield from the pinch-weld. When you try to cut the urethane seal, you might encounter challenges since it is very strong and adhesive. It is important to get the urethane seal from inside so that you do not break the glass and have a mess. The next thing is to lift the windshield and it is important that you seek help because it is a two-person job. After lifting the glass, put it carefully on the ground and it is a good idea to place a towel beneath the old windshield. This is going to avoid the mess of shattered glass where you have parked your vehicle or in the garage.

You should then prepare the pinch-weld for the new windshield by using sandpaper to remove rust from it, then followed by water and a brush to clean away any contaminants. You should then apply a layer of urethane primer to the black band that is around the perimeter of the windshield to prepare for the installation of the new windshield. To read more about how you can install your new windshield, visit the website of Windshield Guru.

Give about 24 hours for urethane dry before you can start driving again. You should then install a window gasket starting from one end and press it into the groove around the entire perimeter of the windshield. The final step is for you to replace the trim around the windshield only if urethane has dried completely. If you follow the above steps, then you are going to replace your windshield within no time. If you’re interested in finding out more about the other best Do-It-Yourself windshield replacement tips, click here.